Other designs

A simple step-up converter.

Step-up converter

This step-up converter is intended for use in a '67 Citroën 2CV. This car, and I use the word loosely, has a 6V battery and won't support a modern radio that needs 12V. The circuit described here converts 6V to 12V at 1A sustained load current.

L in series with (switch // C)

It works something like this:

When the switch is closed an extra current flows through the inductance and stores energy there. The capacitor supplies the load with current during this time.

After the switch opens the capacitor is charged by the energy stored in the inductance and an extra current starts flowing through the load, causing the output voltage to rise (energy is supplied directly from the input source also as long as the diode is forward biased). During this time, the system behaves like a RLC-circuit, so, after a while, the current decreases. The switch is then closed again and the cycle repeats. One could say that charge is pumped from input to output, increasing the output voltage up to the point where there is an equilibrium between the discharging of the capacitor while the switch is closed and the charging by the inductor while the switch is open.

The output voltage equals (ton / toff + 1) x Uin and is controlled by PWM of the switching action. For more information, see the Wikipedia article.

To implement this, I have used the LM2577T-ADJ from National Semiconductor, now Texas Instruments. It operates conform the given discription and is connected like so:

IC Switcher/regulator LM2577T-ADJ (Texas Instruments)
R1 and R2 Voltage devider for monitoring output voltage 20Kohms pot. (Bourns)
Cin Decoupling 0.1μF, 63V MKS condensator (WIMA)
L Use a good quality coil! 160μH toroïd (2.5A, 70mohms, nickel-iron core)
D Current higher than output current! FR603 60V reverse breakdown, 3A Schottky-diode
Rc and Cc Pole-zero compensation network 2200ohms, 5% and 1μF, 63V elco (Philips)
Cout Get a low ESR type! 2200μF, 16V elco (Telecon)

You can download the PCB design here (only 4Kb). It's in CorelDraw 3.0 format (zip compressed).

If you want to design a an other DC/DC converter with different specifications, you might want to take a look at Texas Instrument's site; they have a design tool there that can design your circuit for you.


This page was created by Oscar den Uijl, oscar@den-uijl.nl